I have a Sonos Arc connected to my Epson LS 300 projector by HDMI 2 ARC. I have an Apple TV in HDMI 1.
I have all the CEC buttons turned on in my Epson Projector. Everything works fine until I turn off the Epson projector and turn it back on. When I do that, the sound doesn’t work. I have to go into the Epson menu settings and toggle the CEC switch off and then back on to get the sound to come back on.
The volume buttons on my Apple TV and my Epson remote show a visible volume bar moving and the Sonos lights react as if they’re reading the signal, but no sound comes out unless I go in and toggle the CEC switch.
Best answer by JZiss
Sorry to report this didn’t last long. The issue is not the cord, but it’s the Epson projector allowing the Apple TV to hijack both picture and sound upon restart and that’s why I need to either toggle inputs, or reset the CEC button on the projector or unplug the Sonos HDMI cable out and in again in order to get the Apple TV to play video and the Sonos Arc to play the sound. So I switched to just plugging in the Sonos Arc via optical cable and went old school with the setup so the kids don’t have to do any gymnastics. Hopefully a future firmware update on the Epson will solve this. In the meantime, I’ll have to plug it in manually where there’s Atmos content where the ARC HDMI setting will be most worthwhile.
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
When I say switch inputs, I mean… I have the Apple TV plugged into hdmi 1. If I switch the input to Hdmi 2 and then back to hdmi 1, that corrects the issue.
Good question, but just figured it out by calling Sonos. It was the HDMI cable going from the Sonos into the projector. It came with the Sonos Arc, but something was wrong with it. It was communicating properly. The Sonos rep ran a diagnostic and could see that the system was disconnecting and asked me to switch the cable. As soon as I did that everything worked when I turned off the projector and turned it back on.
Hopefully this helps others in the future. I usually do simple steps like this, but didn’t this time.
Sorry to report this didn’t last long. The issue is not the cord, but it’s the Epson projector allowing the Apple TV to hijack both picture and sound upon restart and that’s why I need to either toggle inputs, or reset the CEC button on the projector or unplug the Sonos HDMI cable out and in again in order to get the Apple TV to play video and the Sonos Arc to play the sound. So I switched to just plugging in the Sonos Arc via optical cable and went old school with the setup so the kids don’t have to do any gymnastics. Hopefully a future firmware update on the Epson will solve this. In the meantime, I’ll have to plug it in manually where there’s Atmos content where the ARC HDMI setting will be most worthwhile.
