Skip to main content
I have 1 x CR100 and 3 x ZP100. 2 x ZP100 are connected via WM:0 and 1 is wireless. They all show as WM:0 on diag.



I did a factory reset on my CR100 and tried to connect it to both of the wired ZP100s. When I press the Mute/Vol+ on the ZP100 the controller shows connecting but after a few minutes it says:

"This controller was unable to connect to a Sonos component. Please try again. (1)"



I know it sees the system because it shows waiting for mute/vol+ and when I press it on the ZP100 it switches to connecting. It just wont connect.



CR100 :

Version : 4.3.2 (build 25133280)

HW Ver: 1.2.3.2-1



Diag from PC app ref# : 7804230



Thanks for any help.
I wish they would just post the steps to manually do it.



That's the thing, you cannot do it manually. They need to push the update to the unit and that requires intervention on their end.
I wish they would just post the steps to manually do it.
You're going to need to contact Sonos and schedule someone to manually connect and possibly update the controllers. I just got off of a call to get mine connected; one went off without a hitch and was able to update without intervention once it was connected, the other one required the technician to manually update it.
Terms & ConditionsCookie settings