What type cartridge are you using with the Rega? Is it Moving Magnet (MM) or Moving Coil (MC)? The pre-amp must be set to match either MM or MC. 

It’s a moving magnet cartridge. All worked fine straight into the Amp before I added the Connect to it. Do you mean that it might need changing now I’ve added in the Connect

? 

Are you able to connect the Connect’s RCA line in to RCA record out or RCA line out on your amp and return to your original setup for the Rega.

Will give it a go. So turntable into pre-amp into RCA in on the amp as it used to be. Then take the RCA out from the Amp into the RCA in on the Connect ?

That is correct. Let us know the outcome.

Yay ! 
 

OK so….. turntable into preamp, preamp into connect, connect out and into hi-fi amp. 
 

Source level High

Audio delay on max. 
 

working through hi-fi and all other Sonos speakers, including via a second Sonos connected to another amp that drives 6 ceiling speakers and a subwoofer in the kitchen. 
 

Thank you so much for your help. 
 

:) 

Glad that you got everything to work. However, from your description it looks like you went back to the connections that you previously indicated were not working? That’s fine as long as everything is to your liking.

BTW…it must have been a slip in your description but the Sonos device driving the in-ceiling speakers is correctly referred to as a Connect:Amp. It was a common mistake when Sonos used similar branding for two different products that were visually similar front-on until one viewed the connections in the rear. 

Once again…enjoy your Sonos!!

Yep. No idea what I did that was different this time, but it works :)

The descriptor should be “another Connect, wired to an amp that drives 6 ceiling speakers…”

Thanks again for the advice and support

P