Hi, I have one amp currently powering one set of speakers on my porch with a volume control. I'm thinking about adding an additional two pairs of speakers inside. Id like to put them on a seperate volume control and if possible also on the same amp. Firstly would it be possible to have all 6 speakers on one amp and second, what would I set the impedence matching to. From what I understand if it were two pairs on one VC id set it to 2X. However I'll have one pair on one VC and two pairs on the other. Would I set both VC to 4x?
Question
1 Amp 2 VC 3 Sets of Speakers
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
I recommend using three Volmue controls. Proper setting depends on the speaker impedance. The control manufacturer should give you a table of suggested settings based on speaker impedance and amplifier minimum impedance capability.
If not matched pairs or you aren't sitting in the optimal position the additional volume control might be nice.
Use a single control for the inside room if you like. If the Volume controls are configured properly, AMP will not care.
Since I know nothing about your speakers, I suggest 4x. If AMP shuts down at high Volume, then go with 8x. 1x on the outdoor speaker and 2x on the indoor pair could work — depending on the speakers, the wiring, and your listening level.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.