Skip to main content
Answered

Line-In not working on Connect:Amp

  • October 20, 2017
  • 5 replies
  • 2010 views

I am trying to use the line-in on my Connect:Amp. However, when I have a device plugged into the phono sockets, the following message appears: "To use line-in, connect a device to a line-in capable sonos player" - i.e. the Connect:Amp is not 'seeing' the Line-in connection.

I have already tried the following:

Swapped the phono cables over - no luck
Rebooted the Sonos Connect:Amp - no luck
Factory reset the Sonos Connect:Amp and added back to the system - no luck

Then I connected the same line-in device to my Sonos Connect - the line-in does show up and works OK

Used the same cables to re-connect to the Connect:Amp - still no luck

I can only conclude that something is up with the Connect: Amp

Can anybody help? Advice would be greatly appreciated.

I have submitted a diagnostics report: #7976997

Thank you!

Best answer by tgsphoto

Really appreciated the replies folks. Having just about given up, I did yet another factory reset tonight ... and hey presto, the line-in shows up. Must have been some kind of glitch. I'm hopeful it won't happen again!
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

5 replies

Airgetlam
  • 44825 replies
  • October 20, 2017
Are you by any chance using the CONNECT:AMP to power surround speakers in a 5.1 setup? According to the FAQ, that automatically turns off the analog input.

  • Author
  • Contributor I
  • 2 replies
  • October 21, 2017
Thanks very much for the reply but no, just a normal stereo set up.

pwt
Forum|alt.badge.img+20
  • Virtuoso
  • 1884 replies
  • October 21, 2017
This probably sounds like a very dumb suggestion, but it’s worth confirming that you’re not accidentally connecting one of the input cables to the subwoofer output. The three terminals for Line In L/R and Sub are the same physically, and lined up next to each other.

  • 19684 replies
  • October 21, 2017
Are you by any chance using the CONNECT:AMP to power surround speakers in a 5.1 setup? According to the FAQ, that automatically turns off the analog input.I wondered about that, but I believe in that situation the line in option would not appear at all in the sources.

If @pwt's suggestion does not prove to solve the problem then the system diagnostic may help as it sounds like it may be a hardware failure.

  • Author
  • Contributor I
  • 2 replies
  • Answer
  • October 21, 2017
Really appreciated the replies folks. Having just about given up, I did yet another factory reset tonight ... and hey presto, the line-in shows up. Must have been some kind of glitch. I'm hopeful it won't happen again!