I have connected the turntable to the Connect:Amp but can't seem to get this to work. I have two Sonos One’s connected to the Connect:Amp. Please could anyone help? Thanks
Best answer by Airgetlam
View original
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.
Userlevel 7
Hi
Assuming as others have suggested your turn table is pre-amped (or using and outboard pre-amp) and line-in is selected; that part of your connection to the Connect:AMP is taken care of. However, when you say you have two Sonos One’s connected to the Connect:Amp that is an inaccurate statement. Hopefully, you mean you have the Sonos’s One’s as a stereo pair named as a room and have set them to autoplay as outlined here.
Here is a good reference between Phono and Line levels. All Sonos line-ins are looking for line level data. You’d want that switch set to ‘line’, as 106rallye suggests, and I indicated in my first response.
Userlevel 7
+17
Line is the amplified signal. Have you tried it?
Hi, Thanks Bruce. The turntable does have output select as ‘line’ or phono’ and had this switched to ‘phono’??
Does this turntable have a built in preamp? If so, you’d need to turn it on, usually marked as ‘line’, rather than ‘phono’. If not, you’d need to purchase a preamp, and place it between the turntable and the Sonos.
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.