Skip to main content
Question

Connect:amp with multiple speaker pairs

  • June 11, 2017
  • 1 reply
  • 638 views
T
We just moved to a new home. There are four sets of speakers built in with the wires twisted to a single pair into the audio cabinet. Each speaker pair's audio is controlled but a reostat device. I'm sure running all four pair simultaneously would melt a connect:amp but would it work if I turned the volume off for three pair and ran only one at a time?

TIA
    This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

    1 reply

    K
    • Kumar
    • June 11, 2017
    Yes, it would work that way, only one speaker would draw current from the amp. You probably could use two amps though, one for two speaker pairs, and run all at the same time. Or use one and run only two pairs at a time.

    The amp won't melt if it comes to that; it has protection circuitry that will cause it to shut down.
    Terms & ConditionsCookie settingsAccessibility statement