undecided between Connect & Connect AMP
Dear all, all our rooms in the house has a Sonos setup apart from one. We have Play 3 and Connect Amps
I have installed 4 x ceiling speakers in this new room where i have access to my Onkyo TX-NR905 Receiver/AMP.
The ceiling speakers are a Micca M-8C and have the following specifications:
Crossover: 6dB/Octave
Frequency Response: 40Hz-20kHz
Impedance: 8 Ohms
Sensitivity: 90dB 1W/1M
Power Handling: 100 Watts (Each)
I wish to install these four speakers in parrallel to the L and R channel of the Onkyo Zone 2 which i have on the AMP and sending the audio signal from a connect through the COAX
The specs of the AMP per channel are 220 W at 6 ohms, 1 kHz, 1 ch driven (IEC)
Would i be able to run 4 speakers through these two channels?
Thanks in advance
I have installed 4 x ceiling speakers in this new room where i have access to my Onkyo TX-NR905 Receiver/AMP.
The ceiling speakers are a Micca M-8C and have the following specifications:
Crossover: 6dB/Octave
Frequency Response: 40Hz-20kHz
Impedance: 8 Ohms
Sensitivity: 90dB 1W/1M
Power Handling: 100 Watts (Each)
I wish to install these four speakers in parrallel to the L and R channel of the Onkyo Zone 2 which i have on the AMP and sending the audio signal from a connect through the COAX
The specs of the AMP per channel are 220 W at 6 ohms, 1 kHz, 1 ch driven (IEC)
Would i be able to run 4 speakers through these two channels?
Thanks in advance
This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.