Cannot add second-hand Boost to my S1 system

  • 11 February 2022
  • 1 reply

Userlevel 7
Badge +20
  • Virtuoso
  • 1868 replies

I’m trying to add a second-hand (ebay) Boost to one of my S1 systems.

On the first setup attempt, the S1 iOS app indicated that a device reset was required. That’s plausible. I’ve now reset the device, twice, generating the expected set of flashing LED sequences.

On several subsequent attempts, the app just doesn’t find the Boost. The Boost is wired to the network, has acquired an IP address, and is pingable from other devices over both the wired and wireless networks. The Boost’s LED is flashing green, as one would expect during setup.

Is it possible that if the Boost was previously used on an S2 system (as is likely), there’s a problem in now adding it to an S1 system?


Best answer by pwt 11 February 2022, 16:14

View original

This topic has been closed for further comments. You can use the search bar to find a similar topic, or create a new one by clicking Create Topic at the top of the page.

1 reply

Userlevel 7
Badge +20

Never mind.

User error: I selected ‘+ Add Product’, instead of scrolling down and selecting ‘+ Add Boost or Bridge’.