Answered

Connecting Turntable, CD Player and Receiver to Sonos system.

  • 22 September 2022
  • 4 replies
  • 50 views

Badge

I have Sonos speakers in several rooms.  I would like to connect my Sony receiver, Sony Turntable and Sony CD Player so that they can play my large vinyl and CD collections over my Sonos System.  I don't have non-Sonos speakers that I want to attach to my receiver, but I do have a Sonos speakers in the room where the equipment is.  What I am thinking of doing is to hook up the turntable and CD player to the receiver, then connect the receiver to a Sonos Port.  My receiver does have a REC OUT connection if that is needed in this scenario. I seem to be getting various opinions from different sources on whether this will work or not.  Is there anyone in this community that can give me solid advice on this topic?  Thanks.

icon

Best answer by Airgetlam 22 September 2022, 22:29

View original

4 replies

Yes, connecting a Port to a line out on a receiver would work fine. In general, you can think of the Sonos Port as a “tape deck” that connects in the same way, i.e. to a tape loop (rec in/play out). It should never be connected to a Phono input, though.

Anything that you then send to the Port from the receiver would play in sync across all your Sonos speakers, assuming you’ve grouped them properly. And, if the other side (the out on the Port to the input on the receiver, the receiver would also play stuff, if you had other speakers connected to it. 

Important to note, however, that anything that you send to the Port (and play on your receiver’s speakers) will be delayed slightly on your Sonos. This isn’t an issue if you’re just using the Sonos speakers. If your receiver is getting the feed back from the Sonos, it will al be in sync, but if you try playing something locally and send it to the Sonos, you’ll hear that delay. 

Badge

Thanks Airgetiam, your quick response was helpful.

Userlevel 7
Badge +21

Don’t have the equipment to test this here.

What would happen if you hooked the Port to the tape-out and tape-in jacks, selected your source on the receiver but also selected the tape-monitor option.

Would the Port send what it saw on the input to the outputs and would it be the delayed signal or just a copy of the inputs.

So: Phono → Rx → Port → Rx

Reply